Value Collection SMPPI-1400870-025B No. 14 Pan Head Sheet Metal Screw

Product Description

The VALUE COLLECTION SMPPI-1400870-025B is a No. 14 pan head sheet metal screw with a Phillips drive and a Type AB point. It measures 7/8 inches in length under the head and is manufactured from Grade 2 steel with a zinc finish. This fastener is designed for driving into sheet metal, light gauge steel, and similar substrates without a pre-tapped hole. It is sold in a pack of 25 and is a standard choice for HVAC techs, electricians, and sheet metal workers who need reliable, corrosion-resistant fasteners for duct work, electrical enclosures, and equipment panels.

This screw is suited for light commercial and residential applications where a No. 14 thread size and pan head profile are required. Typical uses include securing sheet metal duct sections, attaching equipment access panels, fastening junction box covers, and general sheet metal assembly. The zinc finish provides basic corrosion resistance appropriate for indoor and protected outdoor environments. The Type AB point allows the screw to self-tap into pre-drilled or punched sheet metal, reducing installation time in repetitive fastening tasks.

Key Features

• No. 14 thread size with Type AB self-tapping point for sheet metal applications
• 7/8 inch length under head suits standard light-gauge sheet metal thicknesses
• Pan head profile provides a wide bearing surface and low-profile appearance
• Phillips drive compatible with standard power and hand drivers
• Zinc finish offers basic corrosion resistance for indoor and protected installations
• Sold in a pack of 25 for convenience on small jobs and service calls

Compatibility

Designed as a standard No. 14 pan head Phillips sheet metal screw suitable for general sheet metal fastening tasks in HVAC ductwork, electrical enclosures, equipment cabinets, and similar light-gauge steel assemblies.

Installation Notes

This fastener is typically installed by HVAC technicians, electricians, or sheet metal workers using a Phillips-tip power driver or hand screwdriver. For Type AB point screws, a pilot hole or punched starting point in the sheet metal is recommended to control thread engagement and prevent material distortion. Always confirm the substrate thickness is appropriate for a No. 14 fastener to ensure proper thread engagement and pull-out strength. De-energize any electrical enclosure or equipment before fastening panels or covers.