Value Collection SMPPI-1400750-100BX Sheet Metal Screw 100

Product Description

The VALUE COLLECTION SMPPI-1400750-100BX is a No. 14 pan head Phillips sheet metal screw sold in a box of 100. It measures 3/4 inches in length under the head and is manufactured from Grade 2 steel with a zinc finish. The Type AB point allows the screw to self-tap into light-gauge sheet metal, making it a standard fastener in HVAC ductwork fabrication, electrical enclosure assembly, and general sheet metal work. Licensed trades and sheet metal mechanics rely on this fastener for securing duct sections, junction box covers, and light structural panels.

This screw is suited for residential and commercial applications where a reliable, corrosion-resistant fastener is needed in light-gauge steel assemblies. Common uses include HVAC duct connections, metal equipment enclosures, and light structural sheet metal. The pan head profile provides a wide bearing surface and sits flush against the material face without countersinking, making it appropriate for surfaces where a low-profile head is acceptable. The Phillips drive is compatible with standard power drivers used in the field.

Key Features

• Type AB point self-taps into light-gauge sheet metal without a pilot hole in most applications
• Pan head design provides a wide bearing surface and sits flat against the workpiece
• Phillips drive compatible with standard power drivers and hand tools
• Grade 2 steel construction with zinc finish for basic corrosion resistance
• 3/4 inch length under head suits thin to medium gauge sheet metal panels
• Sold in a box of 100 for job-site and service van stock

Compatibility

Designed as a standard No. 14 Type AB pan head Phillips sheet metal screw suitable for light-gauge steel fabrication and assembly work typical in HVAC, electrical, and general sheet metal applications.

Installation Notes

Sheet metal screws of this type are installed by licensed sheet metal workers, HVAC technicians, and electricians. De-energize any electrical enclosure or equipment before fastening panels or covers. Use a power driver set to a controlled torque to avoid stripping the Phillips drive recess or overdriving through thin gauge material. Follow applicable mechanical and electrical codes, including SMACNA duct construction standards and NEC requirements, when securing enclosures or ductwork.