Value Collection SMPPI-1200750-100BX Sheet Metal Screw 100

Product Description

The VALUE COLLECTION SMPPI-1200750-100BX is a No. 12 pan head sheet metal screw with Phillips drive and a Type AB point, sold in a box of 100. It measures 3/4 inches in length under the head and is manufactured from Grade 2 steel with a zinc finish for corrosion resistance. The Type AB point provides fast thread engagement in pre-punched or drilled sheet metal, light-gauge steel ductwork, electrical enclosures, and similar thin-material assemblies. These screws are a staple fastener for HVAC techs, electricians, and sheet metal workers who need reliable, consistent fasteners in volume.

These screws are suited for light-gauge sheet metal fabrication and assembly work encountered in residential and commercial HVAC ductwork, electrical panel and enclosure work, and general sheet metal construction. The pan head profile keeps a low, wide bearing surface that resists pull-through in thin material. The Phillips drive works with standard screw guns and drill drivers commonly found on any trade job site. The box-of-100 quantity is practical for technicians stocking a service van or completing a ductwork installation.

Key Features

• No. 12 thread size for strong holding power in light-gauge sheet metal
• 3/4 inch length under head suits common sheet metal thicknesses
• Type AB point for fast self-tapping engagement without pre-tapping
• Pan head profile provides wide bearing surface and low-profile finish
• Grade 2 steel construction with zinc finish for general corrosion protection
• Box of 100 — volume quantity suited for production work and van stock

Compatibility

Designed as a standard replacement or supply fastener for light-gauge sheet metal assemblies including HVAC ductwork, electrical enclosures, and general sheet metal fabrication where a No. 12 pan head Phillips sheet metal screw with Type AB point is specified.

Installation Notes

Installation is performed by HVAC technicians, electricians, and sheet metal workers using a standard Phillips bit and drill driver or screw gun. Ensure the base material gauge is appropriate for a No. 12 screw to prevent strip-out. Type AB point screws are self-tapping and do not require a pre-tapped hole, but a pilot hole is recommended in harder or thicker stock. Power down any electrical enclosures before fastening into live panels in accordance with NFPA 70 lockout-tagout requirements.