Value Collection SMPFI0-801500-100BX Sheet Metal Screw

Product Description

The VALUE COLLECTION SMPFI0-801500-100BX is a No. 8 flat head Phillips sheet metal screw designed for fastening thin metal panels, ductwork, brackets, and light-gauge sheet metal assemblies. The screw measures 1.5 inches in overall length and is manufactured from Grade 2 steel with a zinc finish that provides corrosion resistance in standard indoor applications. The flat head profile sits flush with the material surface after installation. Sold in a box of 100, this fastener is a practical bulk supply for HVAC installers, electricians, plumbers, and general trade contractors who need a reliable, code-common screw for everyday metal fastening tasks.

This screw is suited for residential and light commercial applications involving sheet metal connections such as HVAC duct assembly, electrical enclosure mounting, metal framing attachments, and general fabrication work. The Type A and Type AB point types allow it to self-start in pre-punched or drilled pilot holes in light-gauge sheet metal without requiring a separate nut. The Phillips drive is compatible with standard power drivers and manual screwdrivers commonly found on any trade job site.

Key Features

• No. 8 thread size for reliable grip in light-gauge sheet metal
• 1.5-inch overall length suits typical panel and ductwork fastening depths
• Flat head profile creates a flush finish at the material surface
• Phillips drive compatible with standard power drivers and hand tools
• Type A and Type AB point types allow use in pre-punched or drilled holes
• Zinc finish provides corrosion resistance for standard indoor environments
• Sold in a 100-count box for bulk job-site supply

Compatibility

Designed as a standard Type A and Type AB No. 8 sheet metal screw for use in light-gauge sheet metal applications including duct work, electrical enclosures, and metal panel assemblies.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and general trade contractors using a Phillips-tip power driver or manual screwdriver. Always verify the pilot hole diameter matches the thread size requirements for the gauge of metal being fastened. Wear appropriate eye protection when driving fasteners into sheet metal. Follow applicable codes including SMACNA duct construction standards for HVAC applications.