Value Collection SMPFI0-800620-100BX Sheet Metal Screw No. 8

Product Description

The VALUE COLLECTION SMPFI0-800620-100BX is a No. 8 flat head Phillips drive sheet metal screw with a 5/8 inch overall length. Manufactured from Grade 2 steel with a zinc finish, this fastener is designed for secure, corrosion-resistant connections in sheet metal assemblies. The Type AB point allows the screw to self-start in thin-gauge metal without pre-drilling in many applications. This box contains 100 pieces, making it a practical supply for field technicians, sheet metal contractors, and HVAC installers who go through fasteners regularly on duct work and equipment panels.

These screws are commonly used in HVAC duct fabrication and assembly, electrical enclosure work, and general sheet metal fabrication. The flat head profile sits flush with the material surface, making it well suited for panel covers, access doors, junction box lids, and other applications where a low-profile fastener is required. The Phillips drive is compatible with standard power drivers and manual screwdrivers used on the job site. Sold in a box quantity of 100.

Key Features

• No. 8 thread size for reliable grip in sheet metal gauge material
• 5/8 inch overall length for thin-gauge sheet metal applications
• Flat head design sits flush with the work surface
• Phillips drive compatible with standard power drivers and hand tools
• Type AB point for self-starting in sheet metal without pre-drilling in many cases
• Zinc finish over Grade 2 steel for basic corrosion resistance

Compatibility

Designed as a general-purpose No. 8 flat head Phillips sheet metal screw suitable for use in HVAC duct assemblies, electrical enclosures, and light-gauge sheet metal fabrication where a flush-mounting fastener is required.

Installation Notes

Sheet metal screws of this type are typically installed by HVAC technicians, sheet metal workers, and electricians using a Phillips bit in a power drill or manual screwdriver. Always de-energize electrical equipment and relieve system pressure before opening panels or enclosures. Pilot holes may be required in heavier gauge material to prevent material deformation. Follow applicable codes including SMACNA standards for duct assembly and NEC requirements for electrical enclosure work.