Value Collection SMPFI-1002000-100BX No. 10 Flat Head Sheet Metal

Product Description

The VALUE COLLECTION SMPFI-1002000-100BX is a No. 10 flat head Phillips drive sheet metal screw designed for fastening thin metal assemblies in HVAC, electrical, and general sheet metal fabrication work. At 2 inches overall length, this Type AB point screw seats flush with the material surface when fully driven, leaving a clean, low-profile finish. Constructed from Grade 2 steel with a zinc finish, it provides corrosion resistance suitable for indoor and light-duty protected applications. This box contains 100 screws. HVAC technicians, sheet metal workers, and electricians use these fasteners when assembling ductwork, junction boxes, equipment enclosures, and panels.

These screws are suited for residential and light commercial applications involving thin-gauge steel sheet metal, including duct connections, equipment access panels, electrical enclosures, and metal framing components. The flat head profile is appropriate where a flush surface is required and countersinking is present or pre-formed into the material. The Phillips drive allows use with standard power drivers and hand screwdrivers commonly found on any service vehicle or job site. Sold in a box of 100, this quantity suits both single-job installs and replenishment of shop or van stock.

Key Features

• No. 10 thread size for reliable grip in standard sheet metal gauges
• 2 inches overall length for deeper bite in layered or thicker sheet assemblies
• Flat head profile seats flush when countersunk
• Phillips drive compatible with standard power and hand drivers
• Type AB point for easy thread engagement in sheet metal without pre-threading
• Zinc finish provides corrosion resistance for indoor and protected environments

Compatibility

Designed as a general-purpose replacement or stock fastener for No. 10 flat head Phillips sheet metal screw applications in HVAC ductwork, electrical enclosures, and light-gauge metal panel assemblies.

Installation Notes

Sheet metal screws are installed by sheet metal workers, HVAC technicians, and electricians as part of standard assembly and service work. Ensure the mating material is properly supported and, where required, countersunk to accept the flat head profile before driving. Use a Phillips bit matched to the screw size to avoid cam-out and head damage. Follow applicable codes such as SMACNA duct construction standards or NEC enclosure requirements when selecting fastener type and spacing.