Value Collection S04064945 Wheel Brush 8 Inches

Product Description

The VALUE COLLECTION S04064945 is an 8-inch diameter wheel brush designed for aggressive surface preparation, deburring, and cleaning on ferrous and non-ferrous materials. Built with crimped brass-coated steel wire, the brush delivers consistent, flexible contact across irregular surfaces without the harshness of knotted wire configurations. It mounts via a 1-1/4-inch arbor hole and is rated to a maximum of 4,500 RPM, making it suitable for bench grinders and stationary pedestal grinders used in fabrication, maintenance, and trade shop environments. Metalworking technicians, pipefitters, and maintenance mechanics are the primary installers and operators of this tool.

This wheel brush is used in shop and field settings where surface conditioning, rust removal, weld splatter cleanup, and scale removal are routine tasks. The 3/4-inch face width and 1-11/32-inch trim length provide good lateral coverage for flat stock, pipe ends, and structural steel sections. The crimped wire configuration is well suited for light-to-medium cleaning passes where fine surface finish is more important than aggressive stock removal.

Key Features

• 8-inch outside diameter for broad surface coverage on bench and pedestal grinders
• Crimped brass-coated steel wire for flexible, controlled surface contact
• 1-1/4-inch arbor hole for direct spindle mounting without adapters on standard grinders
• Rated to 4,500 RPM maximum — suitable for typical bench grinder speeds
• 3/4-inch face width with 1-11/32-inch trim length for consistent wire engagement
• Filament wire diameter up to 0.0099 inches for medium-duty cleaning applications

Compatibility

Designed to fit bench grinders and stationary pedestal grinders with a 1-1/4-inch arbor spindle. Confirm that the grinder's rated no-load RPM does not exceed 4,500 RPM before mounting.

Installation Notes

Installation is performed by qualified machine operators or maintenance mechanics following the grinder manufacturer's arbor mounting procedure. Always power down and lock out the grinder before mounting or removing the wheel brush. Confirm the machine's spindle RPM rating does not exceed the brush's 4,500 RPM maximum before operation. Eye protection and appropriate PPE are required during use per standard shop safety practice.