Value Collection RVB14-5 Ring Terminal 6 Awg Crimp 10 Stud

Product Description

The VALUE COLLECTION RVB14-5 is a partially insulated circular ring terminal designed for crimp connections on 6 AWG wire. The terminal body is copper with a blue vinyl insulation sleeve that partially covers the barrel, leaving the ring exposed for stud mounting. At 1.646 inches long and 0.472 inches wide, this compact terminal fits a No. 10 stud and is suited for permanent electrical terminations in control panels, equipment wiring, and power distribution assemblies. The UL Listed rating confirms it meets recognized safety standards for electrical connectors. Electricians and panel wiring technicians are the primary installers.

This ring terminal is used in residential, commercial, and light industrial electrical applications where a secure, vibration-resistant wire-to-stud connection is required. Typical uses include grounding connections, equipment bonding, terminal block assemblies, and branch circuit terminations where 6 AWG copper wire is routed to a No. 10 stud. The blue color coding follows standard convention for 6 AWG wire gauge identification, helping technicians maintain visual consistency across multi-conductor installations.

Key Features

• Crimp connection type provides a gas-tight, low-resistance termination on 6 AWG wire
• Partially insulated vinyl sleeve protects the barrel while keeping the ring accessible for stud mounting
• Copper contact material ensures good conductivity and corrosion resistance in typical indoor wiring environments
• No. 10 stud size (5.30 mm) accommodates standard machine screws and terminal studs
• Blue color coding identifies 6 AWG compatibility at a glance during installation and inspection
• UL Listed construction meets recognized electrical safety standards

Compatibility

Designed for use with 6 AWG wire and No. 10 stud hardware. Suitable as a standard crimp ring terminal in electrical wiring assemblies where partially insulated, blue-coded terminals are specified.

Installation Notes

Installation should be performed by a licensed electrician following applicable NEC requirements. De-energize the circuit completely before terminating or inspecting any ring terminal connection. Use a calibrated ratcheting crimp tool rated for the terminal barrel size to achieve a proper crimp — an under-crimped connection can result in high resistance or pull-out failure. Do not solder after crimping on a crimp-only terminal, as this can cause brittleness at the barrel edge.