Value Collection RBD412 Half-oval Fender Bumper 12x4 in

Product Description

The VALUE COLLECTION RBD412 is an extruded synthetic rubber half-oval fender bumper designed to protect vehicle fenders, dock edges, trailers, and equipment surfaces from impact and abrasion. The D-shaped cross-section profile measures 12 inches wide by 4 inches high with a 4-inch projection, providing substantial standoff between the protected surface and any contact point. A 0.89-inch bolt hole diameter allows for secure mechanical fastening. The extruded rubber construction delivers consistent cross-section geometry along the full length and resists compression set over repeated impacts. Installation is typically performed by fleet maintenance technicians, marine dock crews, or equipment fabricators.

This bumper suits a wide range of commercial and industrial applications where edge or surface protection is needed. Common installations include truck and trailer fenders, loading dock bumpers, equipment housings, marine dock rails, and industrial machinery guards. The half-oval profile channels impact loads evenly and mounts flush against flat or slightly curved surfaces. At 5 pounds, it is manageable for single-technician installation in most field environments.

Key Features

• Extruded synthetic rubber construction maintains consistent D-shaped profile along the full length
• 12-inch width by 4-inch height profile provides broad surface coverage per mounting point
• 4-inch projection delivers meaningful standoff to absorb and redirect impact energy
• 0.89-inch bolt hole diameter supports standard mechanical fastener attachment
• Rubber material resists abrasion, moisture, and weathering in outdoor or dock environments

Compatibility

Designed as a general-purpose extruded rubber fender bumper for truck, trailer, dock, and industrial equipment applications where a half-oval D-shaped profile with mechanical bolt-through mounting is required.

Installation Notes

Installation is typically performed by maintenance technicians or fabricators using standard hand tools and appropriately sized fasteners through the bolt hole. Ensure the mounting surface is clean, flat, and free of debris before securing the bumper. Avoid overtightening fasteners, which can distort the rubber profile and reduce sealing contact along the mounting flange. Follow applicable equipment manufacturer guidelines for fastener torque and spacing when mounting on regulated vehicles or dock structures.