Value Collection R83922819 No. 10 Flat Head Sheet Metal Screw

Product Description

The VALUE COLLECTION R83922819 is a No. 10 flat head Phillips sheet metal screw manufactured from Grade 18-8 stainless steel. At 2 inches overall length, this screw is designed for fastening thin metal components in HVAC, electrical, and general sheet metal fabrication applications. The flat head profile sits flush with the mating surface upon installation, making it well suited for assemblies where a low-profile finish is required. Grade 18-8 stainless steel construction provides corrosion resistance in both indoor and outdoor environments. Installation is performed with a standard Phillips driver or bit. This fastener is sold in multiples of 100 units per order.

This screw is used across a wide range of trade applications including HVAC ductwork assembly, electrical enclosure fabrication, plumbing equipment mounting, and general sheet metal work. The No. 10 thread size is a common specification in residential and light commercial construction and service work. Its flush-seating flat head makes it appropriate wherever a protruding head would interfere with covers, panels, or adjacent components.

Key Features

• Grade 18-8 stainless steel construction provides corrosion resistance for both indoor and outdoor use
• No. 10 thread size suits standard sheet metal and light-gauge fabrication work
• 2 inches overall length accommodates multi-layer or thicker sheet metal assemblies
• Flat head profile seats flush with the work surface for clean, low-profile installations
• Phillips drive is compatible with standard power drivers and manual screwdrivers
• Sold in quantities of 100 for job-site and shop stocking needs

Compatibility

Designed as a standard No. 10 flat head Phillips sheet metal screw suitable for use with light-gauge steel, aluminum, and other sheet metal materials common in HVAC, electrical, and general fabrication applications.

Installation Notes

Installation is performed by licensed trades or experienced fabricators using a Phillips-tip driver, either manual or power-assisted. Pre-drilling a pilot hole is recommended when fastening heavier-gauge materials to prevent distortion or thread stripping. Ensure the work surface is clean and properly aligned before driving fasteners. Follow applicable NEC or mechanical code requirements for fastener type and spacing in regulated assemblies.