Value Collection R83922200 No. 12 Pan Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION R83922200 is a No. 12 pan head sheet metal screw with a Phillips drive, manufactured from 18-8 stainless steel. It measures 0.75 inches in length under the head. The 18-8 stainless steel grade provides solid corrosion resistance, making this fastener appropriate for both indoor and outdoor applications where moisture or chemical exposure is a concern. Pan head geometry delivers a low-profile, wide-bearing surface that distributes clamping load across the workpiece. Technicians and tradespeople use sheet metal screws like this one to fasten sheet metal panels, ductwork, enclosures, and light-gauge components across HVAC, electrical, and general mechanical work.

This screw is commonly used in HVAC ductwork assembly, electrical enclosure installation, and general sheet metal fabrication. The Phillips drive is compatible with standard power drivers and manual screwdrivers, making it practical for field and shop use. The No. 12 thread size is a common choice for securing panels, access doors, and equipment covers in residential and light commercial applications. Sold in multiples of 100 per order.

Key Features

• No. 12 thread size for moderate clamping strength in light-gauge sheet metal
• 0.75 inch length under head suits typical single-layer and double-layer panel fastening
• 18-8 stainless steel construction resists corrosion in moisture-prone environments
• Pan head profile provides a wide bearing surface and low-profile finish
• Phillips drive works with standard No. 2 Phillips bits and manual drivers

Compatibility

Designed as a general-purpose OEM-style replacement or stock fastener for sheet metal applications in HVAC ductwork, electrical enclosures, and light commercial equipment panels.

Installation Notes

Installation is performed by HVAC technicians, electricians, and sheet metal workers using a No. 2 Phillips driver bit. Pre-drilling a pilot hole is recommended when working with heavier-gauge material to prevent material distortion and reduce drive torque. Power down or de-energize any electrical enclosure before fastening panels. Do not overdrive — stainless steel fasteners are susceptible to galling if run at excessive speed without lubrication.