Value Collection R83922124 No. 6 Pan Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION R83922124 is a No. 6 pan head Phillips drive sheet metal screw designed for fastening thin-gauge metal assemblies in HVAC, electrical, and general sheet metal fabrication work. Measuring 1 inch in length under the head, this screw is constructed from Grade 18-8 stainless steel, providing corrosion resistance suitable for both indoor and outdoor service environments. The pan head profile delivers a broad bearing surface that resists pull-through on light-gauge sheet metal panels and duct work. Licensed tradespeople and sheet metal fabricators rely on this fastener type for consistent, repeatable installations using standard Phillips drive tools.

This screw is well-suited for light commercial and residential applications where corrosion resistance and a low-profile head are required. Common installation scenarios include securing HVAC duct flanges, electrical enclosure covers, junction box knockouts, and general sheet metal panel assembly. The 18-8 stainless steel grade performs reliably in environments exposed to moisture or mild chemical exposure, making it a standard choice for mechanical room and rooftop unit installations.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in wet or outdoor environments
• No. 6 thread size with 1-inch length under head for light-gauge sheet metal fastening
• Pan head profile provides a wide bearing surface to minimize pull-through
• Phillips drive compatible with standard and powered screwdrivers
• Inch measurement system for straightforward sizing in domestic trade applications

Compatibility

Designed as a standard No. 6 pan head Phillips sheet metal screw suitable for light-gauge metal panels, duct assemblies, electrical enclosures, and similar sheet metal fastening applications in HVAC, electrical, and mechanical trades.

Installation Notes

Sheet metal screws should be installed by qualified tradespeople following applicable codes such as SMACNA guidelines for duct fabrication or NEC requirements for electrical enclosures. Power down or de-energize any electrical enclosure or HVAC equipment before fastening covers or panels. Use a correctly sized Phillips bit to avoid cam-out and thread damage. Do not over-torque into thin-gauge material, as stainless steel fasteners can shear if driven beyond material capacity.