Value Collection R80264394 Hex Cap Screw M10 1.50 130mm 18-8 Ss

Product Description

The VALUE COLLECTION R80264394 is a metric hex head cap screw designed for general mechanical fastening applications requiring corrosion resistance and dimensional precision. Sized at M10 x 1.50 with a 130 mm length under head, this fastener uses a partial thread configuration suited for clamping applications where a smooth shank is needed between mating surfaces. Constructed from 18-8 stainless steel with no applied coating, it delivers reliable performance in environments exposed to moisture, mild chemicals, or outdoor conditions. The 17 mm hex drive allows installation with standard hex wrenches or sockets. Sold individually with a minimum order quantity of 10 units.

This screw is appropriate for use in mechanical assemblies, equipment fabrication, structural bracketing, and maintenance applications across industrial, commercial, and trade settings. The metric M10 x 1.50 thread pitch is a standard ISO configuration commonly found in machinery, HVAC mounting hardware, plumbing equipment frames, and general metalwork. The partial thread design makes it well suited for through-bolt applications where full thread engagement is not required or desired across the grip length.

Key Features

• M10 x 1.50 metric thread — standard ISO pitch for broad compatibility in metric assemblies
• 130 mm length under head for use in thicker stock or through-bolt configurations
• 18-8 stainless steel construction provides corrosion resistance without a surface coating
• Partially threaded shank supports accurate clamping and reduces stress concentration in the grip area
• 17 mm hex drive accepts standard sockets and open-end wrenches
• Uncoated finish — no galvanic compatibility concerns from plating in stainless-to-stainless assemblies

Compatibility

Designed as a standard metric hex head cap screw for use in any application requiring an M10 x 1.50 partially threaded fastener in 18-8 stainless steel.

Installation Notes

Installation is performed by mechanics, millwrights, or trade technicians using a 17 mm wrench or socket driver. Fasteners should be torqued to values specified by the equipment manufacturer or applicable engineering standards — do not exceed design torque for the joint material. When installing stainless steel fasteners into stainless tapped holes, apply an anti-seize compound to prevent galling. Inspect thread engagement and shank clearance before final tightening to confirm the partial thread is correctly positioned within the grip zone.