Value Collection R63646164 No. 10 Oval Head Sheet Metal Screw

Product Description

The VALUE COLLECTION R63646164 is a No. 10 oval head sheet metal screw designed for fastening thin-gauge metal panels, brackets, enclosures, and ductwork. The Phillips drive accepts a standard No. 2 Phillips bit. At 0.5 inches overall length, this screw is sized for shallow-depth sheet metal applications where a low-profile, finished-looking head is required. The 18-8 stainless steel construction resists corrosion in moderate-moisture and outdoor-adjacent environments. This fastener is commonly installed by HVAC technicians, electricians, and sheet metal workers during equipment assembly, panel attachment, and enclosure fabrication.

This screw is suited for light-gauge sheet metal work across residential and commercial trade applications. Typical uses include securing HVAC cabinet panels, electrical enclosure covers, junction box covers, and metal trim components. The oval head profile sits slightly above the surface with a countersunk bearing face, providing a cleaner finish than a pan or hex washer head in visible or semi-finished assemblies. The No. 10 thread size is a common standard in trade sheet metal work, compatible with pre-punched or self-drilled pilot holes in thin steel, aluminum, and similar substrates.

Key Features

• No. 10 thread size — a widely used standard in sheet metal and enclosure fastening
• Oval head profile provides a low-profile, finished appearance in visible applications
• Phillips drive accepts a standard No. 2 Phillips bit or bit-tip driver
• 18-8 stainless steel construction offers corrosion resistance in moisture-prone environments
• 0.5 inches overall length suited for thin-gauge sheet metal panels and covers

Compatibility

Designed as an OEM-style replacement or general-use fastener for No. 10 oval head Phillips sheet metal screw applications in HVAC, electrical, and light fabrication work.

Installation Notes

Installation is performed by HVAC technicians, electricians, or sheet metal workers using a No. 2 Phillips screwdriver or power driver with a matching bit tip. Always pilot-drill or use manufacturer-designated punch holes to avoid distorting thin sheet metal. Do not overtorque — stainless fasteners in thin gauge metal are susceptible to thread strip if driven past seating. Follow applicable NEC or equipment manufacturer guidelines when fastening electrical enclosure panels.