Value Collection R63640848 No. 6 Oval Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION R63640848 is a No. 6 oval head Phillips sheet metal screw designed for fastening applications in thin metal, sheet stock, and light structural work. Measuring 0.625 inches in overall length, this screw is manufactured from Grade 18-8 stainless steel, providing solid corrosion resistance in both indoor and outdoor environments. The oval head delivers a low-profile, finished appearance with a slightly rounded crown that sits above the surface. The Phillips drive allows fast engagement with standard power drivers. Sold in a minimum order quantity of 100 pieces per pack, this fastener is suited for production, maintenance, and service work where consistent, corrosion-resistant hardware is required.

This screw is appropriate for use in residential and light commercial applications where sheet metal connections require a clean, countersunk-style finish without full flush seating. Common installation scenarios include HVAC ductwork assembly, electrical enclosure work, sheet metal fabrication, and general mechanical assembly. The 18-8 stainless steel construction makes it a practical choice in humid or corrosive environments where carbon steel fasteners would be prone to rust or staining. Ordered in lots of 100, these screws suit service vehicles, shop stock, and repetitive install work.

Key Features

• No. 6 thread size with 0.625 inch overall length for light-gauge sheet metal applications
• Oval head profile provides a low-profile, finished appearance above the surface
• Phillips drive compatible with standard No. 2 Phillips bits and power drivers
• Grade 18-8 stainless steel construction for corrosion resistance in wet or outdoor environments
• Sold in packs of 100 for shop stock, fleet service, or production use

Compatibility

Designed as a standard No. 6 oval head Phillips sheet metal screw for use with light-gauge sheet metal panels, enclosures, and fabricated assemblies where this thread size and drive type are specified.

Installation Notes

Installation is typically performed by HVAC technicians, electricians, sheet metal fabricators, or general mechanics using a No. 2 Phillips bit with a hand driver or power driver set to a controlled torque to avoid stripping the drive or distorting thin metal. A properly sized pilot hole is recommended in harder or thicker stock to ensure clean thread engagement and prevent material deformation. Fasteners should be installed with the head fully seated against the workpiece surface without over-driving. Follow applicable trade codes and manufacturer assembly guidelines for the specific panel or enclosure being serviced.