Value Collection R63308482 Sheet Metal Screw No 10 Hex Washer

Product Description

The VALUE COLLECTION R63308482 is a No. 10 sheet metal screw designed for fastening into thin metal substrates without a pre-tapped hole. The hex washer head with slotted drive provides a broad bearing surface that resists pull-through while remaining compatible with standard hex drivers or flat-blade screwdrivers. Constructed from 18-8 stainless steel, this fastener delivers solid corrosion resistance in wet or outdoor environments. The 1-1/2 inch length is measured under the head, making it suitable for light-gauge sheet metal applications common in HVAC ductwork, enclosures, and equipment panels. Installation is straightforward for sheet metal workers, HVAC technicians, and general contractors.

This screw is well suited for use in residential and light commercial HVAC duct assemblies, electrical enclosures, access panels, and similar sheet metal fabrication or repair work. The 18-8 stainless steel construction makes it a practical choice where exposure to moisture or mild corrosive conditions is a concern. It is sold in minimum order quantities of 100 pieces, making it appropriate for job-site stocking or repeat service work where consistent fastener supply is needed.

Key Features

• No. 10 thread size for reliable bite in light-gauge sheet metal
• 1-1/2 inch length under head for adequate penetration in standard sheet metal assemblies
• Hex washer head provides a wide bearing surface and reduces pull-through risk
• Slotted drive accepts both flat-blade screwdrivers and hex nut drivers
• 18-8 stainless steel construction for corrosion resistance in damp or outdoor environments
• Inch measurement system for compatibility with standard U.S. trade tooling and spec sheets

Compatibility

Designed as a general-purpose OEM-style replacement or stocking fastener for light-gauge sheet metal applications including HVAC ductwork, equipment enclosures, and access panels.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, sheet metal workers, and electricians using a hex nut driver or flat-blade screwdriver. A pilot hole sized appropriately for No. 10 self-tapping screws is recommended to prevent material distortion in thin-gauge metal. De-energize any electrical equipment and shut down airflow systems before fastening into live enclosures or duct assemblies. Follow applicable codes including SMACNA duct construction standards and NEC requirements for electrical enclosures.