Value Collection R63262064 No. 6 X 3/4 in Flat Head Wood Screw

Product Description

The VALUE COLLECTION R63262064 is a No. 6 flat head wood screw with a 3/4 inch overall length, designed for fastening wood components in light construction, cabinetry, trim work, and general carpentry applications. Constructed from Grade 18-8 stainless steel, this screw offers corrosion resistance suitable for both interior and exterior use. The Phillips drive head allows for consistent torque application with standard Phillips drivers or bits. The flat head profile sits flush with or below the material surface when driven into a countersunk hole, producing a clean finished appearance without a protruding fastener head.

This screw is well suited for residential and light commercial woodworking tasks where moisture exposure or corrosion resistance is a consideration. Typical applications include deck trim, window and door casing, cabinet assembly, and furniture construction. The No. 6 thread size and 3/4 inch length make it appropriate for fastening thinner stock and surface materials where a shorter fastener is required to avoid blowthrough.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in wet or outdoor environments
• Flat head profile for flush or countersunk installation
• Phillips drive for use with standard Phillips bits and power drivers
• No. 6 thread size suited for light-duty fastening in wood substrates
• 3/4 inch overall length appropriate for thin stock and surface layering applications

Compatibility

Designed as a standard No. 6 x 3/4 inch flat head wood screw suitable for general wood fastening applications in residential and light commercial carpentry and woodworking.

Installation Notes

Installation is typically performed by carpenters, finish trades, or general contractors using a Phillips No. 2 bit in a hand driver or power drill. Pre-drilling a pilot hole is recommended when working near the edge of wood stock to prevent splitting. Countersinking the hole prior to driving ensures the flat head seats flush with the surface. Always select the correct screw length to avoid fastener penetration through the back face of the workpiece.