Value Collection R63260623 No.10 Flat Head Wood Screw

Product Description

The VALUE COLLECTION R63260623 is a No. 10 flat head wood screw with a 1.5-inch overall length, designed for fastening wood components in construction, millwork, cabinetry, and general carpentry applications. Machined from brass, this screw resists corrosion and is well suited for environments where steel fasteners would oxidize or stain the surrounding material. The flat head profile sits flush with or below the surface of the workpiece when properly driven, producing a clean finished appearance. A Phillips drive recess accepts a standard No. 2 Phillips bit. Licensed tradespeople and finish carpenters select brass fasteners for trim work, marine applications, and decorative assemblies where both appearance and corrosion resistance matter.

This screw is appropriate for residential and light commercial woodworking tasks including cabinet installation, trim attachment, furniture assembly, and wood panel fastening. The No. 10 thread diameter provides solid holding strength in softwoods, hardwoods, and wood composites. The 1.5-inch length makes it suitable for face-fastening stock up to approximately 1 inch thick where a pilot hole is used. This item is sold in a minimum order quantity of 100 pieces per order, packaged as a single unit of 100.

Key Features

• Brass construction provides corrosion resistance for interior, exterior, and marine-adjacent applications
• Flat head design sits flush with the work surface for a clean, finished appearance
• No. 2 Phillips drive recess works with standard drill drivers and hand screwdrivers
• No. 10 thread size delivers reliable holding power in a range of wood substrates
• 1.5-inch overall length suits face-fastening of typical dimensional lumber and cabinet stock

Compatibility

Designed as a standard No. 10 flat head Phillips drive wood screw suitable for general wood fastening in residential and light commercial carpentry, cabinetry, and millwork installations.

Installation Notes

A licensed carpenter or qualified tradesperson should pre-drill a pilot hole sized appropriately for the No. 10 thread to prevent splitting, particularly in hardwoods or near board edges. Use a No. 2 Phillips bit to drive the screw to avoid cam-out and head damage. Apply consistent, controlled torque to seat the flat head flush without overdriving into the wood surface. Follow applicable building codes and manufacturer guidelines for fastener spacing and load requirements in structural or finish applications.