Value Collection R63234841 Hex Lag Screw 3/8 in Stainless

Product Description

The VALUE COLLECTION R63234841 is a hex head lag screw designed for heavy-duty fastening applications where corrosion resistance is required. Measuring 3/8 inches in diameter with a 3-1/2 inch length under head, this fastener is manufactured from 18-8 grade stainless steel with an uncoated finish. Lag screws in this size range are installed by electricians, plumbers, HVAC technicians, and general contractors when anchoring equipment, brackets, structural members, or support assemblies to wood substrates. The hex drive head accepts standard hex socket or wrench tooling for high-torque installation.

This lag screw is suited for both residential and light commercial applications where a corrosion-resistant fastener is needed in outdoor, high-humidity, or chemically exposed environments. Common uses include securing pipe hangers, equipment mounting rails, electrical enclosure supports, and structural hardware to wood framing. The 18-8 stainless steel grade provides reliable performance in wet service conditions where carbon steel fasteners are not appropriate.

Key Features

• 18-8 grade stainless steel construction for corrosion resistance in wet and outdoor environments
• 3/8 inch diameter with 3-1/2 inch length under head for deep anchoring in wood substrates
• Hex head drive accepts standard wrenches and hex sockets for high-torque installation
• Uncoated finish — no coating to chip, flake, or interfere with stainless steel performance
• Lag thread form for wood anchoring of equipment, brackets, and structural hardware

Compatibility

Designed as a standard hex head lag screw for use in wood anchoring applications requiring a 3/8 inch diameter, 3-1/2 inch length under head fastener in 18-8 stainless steel.

Installation Notes

A pre-drilled pilot hole is strongly recommended before driving lag screws into wood to prevent splitting and reduce installation torque. Power down or de-energize any equipment before anchoring nearby electrical or HVAC components. Use a properly sized hex socket or open-end wrench — do not use pliers, which can round the hex head. Installation should comply with applicable building codes and equipment manufacturer anchoring requirements.