Value Collection R63034268 1/4-20 Oval Head Phillips Screw

Product Description

The VALUE COLLECTION R63034268 is a 1/4-20 UNC machine screw designed for general-purpose fastening applications where corrosion resistance matters. It features an oval head profile with a Phillips drive and is manufactured from Grade 18-8 stainless steel with a bright, uncoated finish. The overall length is 5/8 inches, measured from the top of the head to the tip, and the length under the head is also 5/8 inches. This screw is used by electricians, plumbers, HVAC technicians, and general maintenance trades in both residential and light commercial settings where stainless hardware is required.

The oval head design sits slightly above the surface with a tapered underside, making it well suited for countersunk or pre-chamfered holes where a low, finished appearance is desired. The Phillips drive allows for quick installation with standard power or hand tools. Grade 18-8 stainless steel provides good resistance to rust and mild chemical exposure, making this screw appropriate for interior and exterior applications including panel mounting, enclosure assembly, and equipment fastening in humid or corrosive environments.

Key Features

• 1/4-20 UNC thread for compatibility with standard inch-series tapped holes and nuts
• Oval head profile with tapered underside for a flush, finished look in countersunk applications
• Phillips drive for fast installation with common hand and power tools
• Grade 18-8 stainless steel construction for corrosion resistance in wet or outdoor environments
• Bright, uncoated finish with no plating that could chip or flake
• Overall and under-head length of 5/8 inches for precise, consistent fitment

Compatibility

Designed for use in any application requiring a 1/4-20 UNC threaded fastener with an oval head and Phillips drive in stainless steel construction.

Installation Notes

Installation does not require specialized tools beyond a standard Phillips screwdriver or bit. Ensure mating threads are clean and free of debris before driving the screw. Avoid over-torquing stainless steel fasteners, as 18-8 alloy is susceptible to galling when threads are driven too aggressively without lubrication. Power down or de-energize any electrical enclosure before accessing panels where fasteners are being replaced.