Value Collection R63032474 8-32 X 1.5 in Oval Phillips Screw

Product Description

The VALUE COLLECTION R63032474 is an 8-32 x 1.5-inch oval head machine screw with a Phillips drive, manufactured from 18-8 stainless steel with a bright, uncoated finish. The oval head profile sits flush to slightly countersunk against the mating surface, providing a clean, low-profile appearance without a washer. The 18-8 stainless steel construction resists corrosion in wet, humid, or mildly chemical environments. Overall length is 1.5 inches with 1.5 inches of thread length measured from under the head. This is a standard UNC (Unified National Coarse) thread form at 8-32. These screws are used by HVAC technicians, electricians, plumbers, and general tradespeople for panel fastening, equipment assembly, and mechanical connections.

This screw is suited for light-gauge sheet metal panels, electrical enclosures, HVAC equipment cabinets, access covers, and general mechanical assemblies requiring a corrosion-resistant fastener. The Phillips drive is compatible with standard Phillips bits and screwdrivers common in field and shop environments. The UNC thread form mates with standard 8-32 tapped holes and nuts. This SKU is sold in a minimum order quantity of 100 pieces per order.

Key Features

• 8-32 UNC thread, 1.5-inch overall length with full-length thread under head
• Oval head profile for low-profile, countersunk-adjacent seating without a washer
• Phillips drive compatible with standard No. 2 Phillips bits
• 18-8 stainless steel construction for corrosion resistance in wet or humid service environments
• Bright, uncoated finish — no coating to chip, flake, or interfere with electrical grounding contact
• Inch measurement system, UNC thread form

Compatibility

Designed as a standard 8-32 UNC machine screw for use in any application requiring an 8-32 tapped hole or nut, including electrical panels, HVAC equipment enclosures, and general mechanical assemblies.

Installation Notes

Install with a No. 2 Phillips screwdriver or matching power bit. Ensure the mating hole is properly tapped to 8-32 UNC before driving to avoid cross-threading or fastener damage. Do not overtorque stainless steel fasteners, as galling can occur — apply a small amount of anti-seize compound when fastening into stainless or aluminum tapped holes for ease of future removal. Follow applicable mechanical or electrical codes when using fasteners in code-governed assemblies.