Value Collection R63032121 Machine Screw 6-32 Phillips

Product Description

The VALUE COLLECTION R63032121 is a 6-32 x 0.75 inch oval head Phillips machine screw manufactured from 18-8 stainless steel with a bright, uncoated finish. It uses UNC (Unified National Coarse) thread form and is sized for standard 6-32 tapped holes. The oval head profile sits slightly above the surface with a countersunk underside, providing a low-profile finished appearance on visible assemblies. Overall length and length under head are both 0.75 inches. This fastener is suited for light mechanical assembly work across HVAC, electrical enclosures, panel fabrication, and general equipment maintenance applications.

This screw is used in residential and commercial applications wherever a corrosion-resistant 6-32 fastener is required. The 18-8 stainless steel construction makes it appropriate for environments with moisture exposure or where carbon steel fasteners would be undesirable. Typical install scenarios include securing electrical panels, control board housings, access covers, and light-duty equipment components. It is sold and ordered in multiples of 100 units per package.

Key Features

• 6-32 UNC thread form for compatibility with standard 6-32 tapped holes and hex nuts
• 18-8 stainless steel construction provides corrosion resistance in wet or humid environments
• Oval head profile delivers a low-profile, finished appearance on countersunk applications
• Phillips drive for use with standard Phillips screwdrivers or bits
• Bright, uncoated finish — no plating that could affect dimensional tolerance in close-fit applications
• Sold in quantities of 100 for shop stock and service van inventory replenishment

Compatibility

Designed as a standard 6-32 UNC machine screw for use in any application requiring that thread size, including electrical panels, control enclosures, access covers, and light-duty mechanical assemblies.

Installation Notes

Installation requires a Phillips screwdriver or a Phillips bit in a power driver set to a low torque setting to avoid stripping the head. When threading into tapped holes, ensure the mating hole is clean and properly tapped to 6-32 UNC specification before driving. Do not overtighten stainless steel fasteners in stainless steel tapped holes, as galling can occur — apply a small amount of anti-seize compound if the mating material is also stainless steel. Verify applicable equipment manufacturer guidelines and relevant codes before use in listed electrical enclosures.