Value Collection R63031683 8-32 X 1.25 in Pan Head Phillips Screw

Product Description

The VALUE COLLECTION R63031683 is an 8-32 x 1.25-inch pan head machine screw with a Phillips drive, manufactured from 18-8 stainless steel with a bright, uncoated finish. The 8-32 thread designation indicates a Unified National Coarse (UNC) thread form at a number 8 diameter, making this a common fastener for light-gauge metal assemblies, enclosures, and panel work. The pan head profile provides a low-profile, wide-bearing surface suited for flush or near-flush installations. Length is measured under the head at 1.25 inches. These fasteners are typically installed by electricians, HVAC technicians, sheet metal workers, and general maintenance trades in equipment assemblies and control panel fabrication.

This screw is suited for residential and commercial applications where corrosion resistance is required. The 18-8 stainless steel construction makes it appropriate for use in humid environments, outdoor enclosures, or any installation where carbon steel fasteners would be prone to rust. Typical use cases include securing electrical panel covers, HVAC equipment access panels, junction box covers, and light structural assemblies. These screws are sold with a minimum order quantity of 100 units per order, packaged as one unit per package.

Key Features

• 8-32 UNC thread form for wide compatibility with standard tapped holes and hex nuts
• 18-8 stainless steel construction for corrosion resistance in humid or outdoor environments
• Pan head profile provides a broad bearing surface and low installed height
• Phillips drive for use with standard Phillips screwdrivers and power drivers
• Bright, uncoated finish with no plating or coating to flake or degrade
• Length under head measured at 1.25 inches for consistent thread engagement depth

Compatibility

Designed as a standard 8-32 UNC machine screw for use in any pre-tapped or threaded hole conforming to the 8-32 inch-series thread standard.

Installation Notes

Install using a Phillips screwdriver or power driver with the appropriate bit size to avoid cam-out and fastener damage. Verify that the mating hole is tapped to the 8-32 UNC specification before installation. Do not overtighten stainless steel fasteners into stainless threaded holes, as galling can occur; apply an appropriate anti-seize compound when mating stainless to stainless threads. Follow all applicable codes and equipment manufacturer guidelines when fastening electrical enclosures or HVAC equipment panels.