Value Collection R55000128 No. 6 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000128 is a No. 6 self drilling screw with a hex washer head and hex drive, manufactured from Grade 410 stainless steel. The 1-inch length under head measurement makes it well suited for light-gauge metal fastening applications where a pre-drilled pilot hole is not required. The No. 2 drill point bores through material and threads simultaneously, reducing installation steps. Grade 410 stainless steel provides corrosion resistance and mechanical strength for both interior and exterior applications. This screw is sold individually but requires a minimum order quantity of 100 units.

This fastener is used in light commercial and residential construction, HVAC ductwork assembly, metal stud framing, roofing, and general sheet metal fabrication. It is appropriate for use in applications where stainless steel is specified for corrosion resistance, such as coastal environments or areas exposed to moisture. Installers in HVAC, roofing, and light construction trades commonly use this screw type when attaching thin-gauge metal panels or brackets.

Key Features

• No. 2 drill point eliminates the need for a pre-drilled pilot hole in light-gauge metal
• Hex washer head provides a built-in bearing surface and resists pull-through
• Hex drive allows use with standard hex bit drivers and nut drivers
• Grade 410 stainless steel construction offers corrosion resistance for wet or outdoor environments
• 1-inch length under head suits thin-gauge sheet metal and panel fastening

Compatibility

Designed as a standard No. 6 self drilling screw for use in light-gauge sheet metal, HVAC ductwork, roofing panels, and similar thin-material fastening applications where a No. 2 drill point is appropriate.

Installation Notes

Installation is typically performed by HVAC technicians, sheet metal workers, roofers, or general construction tradespeople using a hex bit driver or nut driver. Ensure material thickness is within the rated capacity of a No. 2 drill point before driving. Apply consistent axial pressure during installation to allow the drill point to engage cleanly without walking. Do not overdrive, as stripping can compromise the fastening integrity of stainless steel screws in thin-gauge material.