Value Collection R55000094 No. 10 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000094 is a No. 10 self drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. Featuring a flat head profile with Phillips drive, this screw measures 1 inch overall length and is manufactured from Grade 410 stainless steel, offering good corrosion resistance and mechanical strength. The No. 3 drill point bores through material and threads in a single operation, reducing installation time on metal fabrication, HVAC ductwork, electrical enclosures, and light structural assembly. Electricians, HVAC technicians, and sheet metal workers rely on this screw type for consistent performance in both interior and exterior applications.

This screw is suited for light-gauge metal-to-metal and metal-to-substrate fastening in residential and commercial trade applications. The flat head sits flush with the work surface, making it appropriate where a low-profile finish is required. Grade 410 stainless steel construction resists rust in moderate-moisture environments, including mechanical rooms, rooftop equipment curbs, and equipment panel enclosures. Sold in minimum order quantities of 100 units per order.

Key Features

• No. 3 drill point self-taps and threads in one step — no pilot hole required
• Flat head profile seats flush with the work surface for a clean finish
• Phillips drive compatible with standard and powered screwdrivers
• Grade 410 stainless steel for corrosion resistance in moderate-moisture environments
• 1 inch overall length suits light-gauge sheet metal and enclosure panel work
• No. 10 screw size provides reliable thread engagement in thin metal substrates

Compatibility

Designed as a general-purpose self drilling fastener for light-gauge metal assemblies typical in HVAC, electrical, and sheet metal trade work.

Installation Notes

Installation is performed by licensed electricians, HVAC sheet metal mechanics, and plumbers during equipment rough-in or enclosure assembly. Use a Phillips-tip bit sized for No. 10 fasteners and set clutch torque appropriately for the gauge of material being fastened to avoid stripping. Power down any electrical enclosure or equipment panel before fastening near live components. Do not overtighten — the self drilling point can breach thin stock if excessive force is applied.