Value Collection R55000072 No. 6 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000072 is a No. 6 self drilling screw with a flat head and Phillips drive, manufactured from Grade 410 stainless steel. It features a No. 2 drill point that eliminates the need for a pilot hole, allowing the fastener to drill, tap, and drive in a single pass. The overall length measures 3/4 inches. These screws are suited for light-gauge metal fastening applications and are installed by electricians, HVAC technicians, sheet metal workers, and general tradespeople who require a corrosion-resistant, self-starting fastener in stainless steel construction.

This screw is designed for use in light sheet metal and similar thin-material assemblies where a flush, countersunk finish is required. The flat head profile sits flush with or below the surface upon full drive, making it appropriate for applications where a low-profile fastener is necessary. Grade 410 stainless steel provides moderate corrosion resistance and good hardness, making this fastener suitable for both indoor and outdoor installations where mild corrosive exposure is expected. It is sold in quantities of 100 units minimum per order.

Key Features

• No. 2 drill point self-starts through light-gauge material without a pilot hole
• Flat head design provides a flush, countersunk finish at the surface
• Phillips drive compatible with standard No. 2 Phillips bits and screwdrivers
• Grade 410 stainless steel construction offers corrosion resistance and durability
• 3/4 inch overall length suited for thin sheet metal and light substrate fastening

Compatibility

Designed as an OEM-style replacement or standard-use fastener for light-gauge sheet metal applications requiring a No. 6 flat head self drilling screw with a No. 2 drill point.

Installation Notes

Install using a No. 2 Phillips bit with a variable-speed drill or driver set to an appropriate clutch setting to avoid overdriving the flat head. Power down any equipment or panel before fastening into metal enclosures or electrical housings. Do not over-torque, as stainless steel fasteners are susceptible to galling if driven too aggressively. Follow applicable trade codes for the specific installation environment.