Value Collection R55000020 No. 6 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000020 is a No. 6 pan head self drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. The No. 2 drill point cuts through material and taps its own thread in a single pass. Made from grade 410 stainless steel, this screw delivers corrosion resistance suitable for both indoor and light outdoor applications. The Phillips drive pan head provides a low-profile seating surface and is compatible with standard power drivers. At 1 inch length under head, it is sized for light-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar trade applications. Licensed tradespeople and experienced installers use this fastener wherever a self-tapping, self-drilling solution is required.

This screw is well suited for light-gauge metal fastening in HVAC, electrical, and general mechanical trade work. Typical uses include securing sheet metal panels, joining duct sections, attaching electrical junction box covers, and anchoring thin-gauge steel components. The pan head profile distributes clamping load evenly across the material surface, reducing the risk of pull-through on thinner substrates. The grade 410 stainless steel construction makes it a practical choice in environments with moderate moisture exposure.

Key Features

• No. 2 drill point self-drills and self-taps in one step — no pilot hole required
• Grade 410 stainless steel construction for corrosion resistance
• Pan head profile provides wide bearing surface and low-profile finish
• Phillips drive compatible with standard power drivers and hand tools
• 1 inch length under head suits light-gauge sheet metal and enclosure work
• Inch measurement system; No. 6 screw size

Compatibility

Designed as a standard No. 6 self drilling screw for use in light-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar thin-gauge steel fastening applications where a self-tapping, self-drilling fastener is required.

Installation Notes

Self drilling screws of this type are installed by HVAC technicians, electricians, and sheet metal workers using a standard Phillips bit in a corded or cordless power driver. No pilot hole is needed, but consistent perpendicular alignment with the workpiece is important to prevent bit cam-out and ensure clean thread formation. Do not overdrive — set the clutch on the driver to avoid stripping the head or compressing the material beyond the design limit. Follow applicable codes such as the NEC or SMACNA standards when fastening electrical enclosures or duct assemblies.