Value Collection R55000018 No. 6 Pan Head Self Drilling Screw

Product Description

The VALUE COLLECTION R55000018 is a No. 6 self drilling screw with a pan head and Phillips drive, designed for fast, reliable fastening without a pre-drilled pilot hole. Built from Grade 410 stainless steel, this screw offers solid corrosion resistance and mechanical strength in demanding service environments. The No. 2 drill point bites cleanly through light-gauge metal and similar substrates. The 3/4-inch length under head suits thin-material applications where minimal penetration depth is required. Sold in multiples of 100, this fastener is a standard-use item for HVAC techs, sheet metal workers, plumbers, and other trade professionals who need consistent, quality fasteners on every job.

This screw is well suited for light-gauge sheet metal assembly, HVAC ductwork and equipment panel fastening, electrical enclosures, and similar trade applications where a self-tapping, self-drilling fastener is required. The pan head profile sits low and distributes clamping load across a wider bearing surface, making it a practical choice for thin sheet stock where a countersunk head would not seat properly. Grade 410 stainless steel construction makes it appropriate for both indoor and moderate outdoor exposure applications where mild corrosion resistance is needed.

Key Features

• No. 2 drill point drills its own pilot hole, eliminating the need for a separate drilling step
• Pan head profile provides a broad bearing surface on thin-gauge sheet material
• Phillips drive compatible with standard power screwdrivers and impact drivers
• Grade 410 stainless steel construction for corrosion resistance and mechanical strength
• 3/4-inch length under head suits light-gauge and thin-panel fastening applications
• Sold in multiples of 100 for consistent jobsite or shop inventory management

Compatibility

Designed as a general-purpose No. 6 self drilling fastener suitable for light-gauge sheet metal and similar substrates commonly encountered in HVAC, plumbing, and electrical trade work.

Installation Notes

Install with a Phillips-tip power screwdriver or impact driver set to an appropriate torque clutch setting to avoid stripping the drive recess or overdriving the fastener. Ensure the mating material is within the rated drilling capacity of a No. 2 drill point before driving. Wear appropriate eye protection when using self drilling screws at speed. Follow applicable building and mechanical codes when fastening structural or pressure-boundary components.