Value Collection R52001193 Hex Head Lag Screw 3/8 in Steel

Product Description

The VALUE COLLECTION R52001193 is a hex head lag screw designed for heavy-duty fastening applications in wood and similar structural substrates. The screw measures 3/8 inches in diameter with a 6-inch length under the head, giving it strong holding power in demanding connections. Constructed from AISI 1006 steel with a hot dipped galvanized finish, it resists corrosion in exterior and wet-area installations. This fastener conforms to ASME B18.2.1 dimensional standards, making it a reliable choice for contractors, carpenters, and general tradespeople who need consistent, code-compatible hardware on the job.

Hex head lag screws in this size range are commonly used in wood framing, ledger board attachment, deck construction, and structural timber connections. The 3/8-inch shank provides adequate shear and withdrawal strength for residential and light commercial structural work. The hot dipped galvanized coating makes this fastener suitable for pressure-treated lumber and outdoor environments where bare steel would corrode prematurely. Licensed contractors and experienced tradespeople typically select this fastener size for applications governed by building code load requirements.

Key Features

• 3/8-inch diameter with 6-inch length under head for deep, high-strength engagement
• Hot dipped galvanized finish provides corrosion resistance in exterior and treated-lumber applications
• AISI 1006 steel construction meets Grade 1006-1022 material specifications
• Conforms to ASME B18.2.1 dimensional standards for consistent fitment
• Hex head drive allows installation with a standard socket or hex wrench

Compatibility

Designed as a standard hex head lag screw for use in wood-to-wood and wood-to-structural connections where a 3/8-inch diameter, 6-inch lag fastener is specified.

Installation Notes

Lag screws of this size are typically installed by carpenters, framers, or general contractors using a socket wrench or impact driver fitted with the appropriate hex socket. Pre-drilling a pilot hole sized to the shank diameter is standard practice to prevent wood splitting and reduce drive torque. When installing into pressure-treated lumber, use only fasteners rated for contact with treated wood, such as hot dipped galvanized hardware. Consult applicable building codes for required edge distances, spacing, and load ratings before installation.