Value Collection R52000861 6 Oval Head Phillips Screw

Product Description

The VALUE COLLECTION R52000861 is a No. 6 oval head Phillips drive sheet metal screw designed for fastening thin metal panels, brackets, and sheet metal assemblies. Manufactured from AISI 1016 steel with a zinc plated finish, this screw provides corrosion resistance suitable for general-purpose interior metalwork. The overall length is 1 inch, and the Phillips No. 2 drive head allows for fast installation with a standard bit. It conforms to ANSI/ASME B18.6.4, ASME B18.6.3, and SAE J933 standards, making it appropriate for applications requiring dimensional compliance. Sold individually but ordered in multiples of 100.

This screw is used in HVAC panel assembly, electrical enclosure fabrication, ductwork, light-gauge metal framing, and general sheet metal work. The oval head profile sits slightly above the surface with a countersunk bearing face, offering a finished appearance while maintaining a secure seating. Electricians, HVAC technicians, and sheet metal workers commonly specify this style when a low-profile decorative fastener is needed on exposed metal surfaces. It is suitable for residential and light commercial applications.

Key Features

• AISI 1016 steel construction for reliable tensile strength in sheet metal applications
• Zinc plated finish for corrosion resistance in typical indoor environments
• Oval head Phillips drive accepts a standard No. 2 Phillips bit
• 1 inch overall length suitable for light-gauge sheet metal
• Meets ANSI/ASME B18.6.4, ASME B18.6.3, and SAE J933 dimensional standards
• Ordered in multiples of 100 for jobsite and shop supply use

Compatibility

Designed as a standard No. 6 oval head Phillips sheet metal screw for use in light-gauge steel panels, HVAC equipment housings, electrical enclosures, and similar thin-metal assemblies requiring a countersunk oval head fastener.

Installation Notes

Sheet metal screws of this type are typically installed by HVAC technicians, electricians, or sheet metal workers using a No. 2 Phillips bit in a power driver or manual screwdriver. Pre-drilling a pilot hole in the base material is recommended to prevent metal deformation and ensure proper seating of the oval head. Avoid over-torquing, which can strip the drive or distort thin metal panels. Follow applicable codes and manufacturer guidelines for fastener spacing when used in structural or code-governed assemblies.