Value Collection R52000855 Oval Head Phillips Screw 6

Product Description

The VALUE COLLECTION R52000855 is a No. 6 oval head Phillips drive sheet metal screw designed for fastening sheet metal, light-gauge steel, and similar thin-material assemblies. Manufactured from AISI 1016 steel with a zinc plated finish, this screw delivers corrosion resistance suitable for general trade and industrial applications. The overall length is 3/4 inches, and the Phillips No. 2 drive allows for quick installation with standard power or hand drivers. It meets ANSI/ASME B18.6.4, ASME B18.6.3, and SAE J933 dimensional standards, making it a drop-in fit wherever those specifications are called out on drawings or BOMs.

This screw is commonly used in HVAC duct fabrication, electrical enclosure assembly, light-gauge steel panel work, and general sheet metal construction. The oval head profile sits slightly above the surface with a finished, low-profile dome appearance, making it appropriate for visible fastening locations where a flush or countersunk look is preferred. Installers in HVAC, electrical, and mechanical trades reach for this fastener when assembling access panels, junction boxes, equipment covers, and similar thin-metal components.

Key Features

• AISI 1016 steel construction for reliable tensile strength in sheet metal applications
• Zinc plated finish for corrosion resistance in standard indoor environments
• Oval head profile provides a low dome appearance suitable for visible fastening locations
• No. 2 Phillips drive compatible with standard power and hand drivers
• Meets ANSI/ASME B18.6.4, ASME B18.6.3, and SAE J933 dimensional standards
• 3/4 inch overall length suits light-gauge sheet metal and panel assembly work

Compatibility

Designed as a standard No. 6 sheet metal screw suitable for light-gauge steel, sheet metal panels, and thin-material assemblies where ANSI/ASME B18.6.4 or SAE J933 specifications are required.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and general mechanical tradespeople using a No. 2 Phillips bit with a hand driver or low-torque power driver. Pre-drilling a pilot hole appropriate for the gauge of material being fastened is recommended to avoid stripping or distorting thin sheet metal. Avoid over-driving, as the self-tapping thread form can strip light-gauge material if excessive torque is applied.