Value Collection R52000261 Flat Head Wood Screw No. 4

Product Description

The VALUE COLLECTION R52000261 is a No. 4 flat head wood screw with a Phillips drive, manufactured from brass and built to ASME B18.6.1 standards. At 1 inch overall length, this screw is sized for light-duty fastening tasks in wood substrates where corrosion resistance and a flush-finish countersunk head are required. The brass construction resists rust and galvanic corrosion, making it a reliable choice in humid or chemically active environments. Sold in a minimum order quantity of 100 units, this screw suits contractors, finish carpenters, and tradespeople who need consistent, code-compliant fasteners in volume.

This screw is used in residential and light commercial woodworking and finish applications. Typical install scenarios include cabinetry, trim work, electrical enclosure mounting panels, and plumbing access panel assembly where a flush-seated fastener is required. The flat head profile countersinks cleanly into softwood and hardwood, producing a finished surface without a protruding head. The Phillips drive provides compatibility with standard power drivers and manual screwdrivers common in any trade kit.

Key Features

• Brass construction resists corrosion and is suitable for humid or chemically active environments
• Flat head profile countersinks flush with the work surface for a clean finish
• Phillips drive compatible with standard power drivers and hand screwdrivers
• Meets ASME B18.6.1 dimensional and performance standards
• 1 inch overall length suits light-duty wood fastening applications
• Available in multiples of 100 for consistent volume supply on the job

Compatibility

Designed as a standard No. 4 flat head Phillips wood screw per ASME B18.6.1, suitable for use in softwood and hardwood substrates wherever a countersunk brass fastener of this thread size and length is specified.

Installation Notes

Installation is performed with a No. 2 Phillips bit using a power driver or manual screwdriver. Pre-drilling a pilot hole is recommended in hardwood to prevent splitting and to ensure proper seating of the flat head. Countersink the receiving surface to match the head angle before driving. No special certifications are required to install general-purpose wood screws, but always follow applicable building codes and manufacturer guidelines for the assembly being fastened.