Value Collection R50000404 No. 10 Self Drilling Screw

Product Description

The VALUE COLLECTION R50000404 is a No. 10 self-drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. Built with a hex washer head and hex drive, it delivers strong torque transfer and a broad bearing surface that resists pull-through. The 1/2-inch length under head makes it well suited for thin-material applications where a short, controlled bite is required. Constructed from steel with a zinc-plated finish, it resists corrosion in standard interior and light-duty exterior environments. This screw is sold in minimum quantities of 100, consistent with professional trade use on production or service work.

This screw is a practical choice for HVAC sheet metal work, electrical enclosure assembly, light structural framing, and general sheet-to-sheet or sheet-to-substrate fastening. The No. 2 drill point self-starts through light-gauge steel and similar thin materials without pre-drilling, saving time on repetitive fastening tasks. It is commonly used by HVAC technicians, sheet metal workers, and electricians installing panels, brackets, and duct components.

Key Features

• No. 2 drill point self-taps through light-gauge material without a pilot hole
• Hex washer head provides a wide bearing surface to resist pull-through
• Hex drive allows high torque transfer with standard hex-tip drivers or nut drivers
• Steel construction with zinc-plated finish for corrosion resistance in standard service environments
• 1/2-inch length under head suits thin-material and close-tolerance fastening applications
• Sold in multiples of 100, appropriate for production and service trade use

Compatibility

Designed as a standard No. 10 hex washer head self-drilling screw compatible with light-gauge steel sheet metal assemblies and enclosures common in HVAC, electrical, and general trade applications.

Installation Notes

Install with a hex-tip power driver or manual nut driver sized for the hex washer head. Verify material thickness is appropriate for a No. 2 drill point before driving to avoid stripping or incomplete thread engagement. Do not overdrive — the washer head is designed to seat flush without crushing the substrate. Follow applicable industry codes and manufacturer guidelines for fastener spacing and load requirements.