Value Collection R50000199 Sheet Metal Screw No. 10 2 in

Product Description

The VALUE COLLECTION R50000199 is a No. 10 pan head sheet metal screw designed for fast, secure fastening in light-gauge sheet metal applications. It features a Phillips drive for quick installation with standard power or hand tools and a Type A / Type AB point for self-starting entry into pre-punched or pierced sheet metal. The screw measures 2 inches in length under the head and is manufactured from Grade 2 steel with a zinc finish that provides basic corrosion resistance in dry indoor environments. At 0.013 pounds per unit, it is suited for high-volume fastening tasks.

This screw is used in HVAC ductwork assembly, electrical enclosure fabrication, light-gauge metal panel attachment, and general sheet metal fabrication in both residential and commercial settings. HVAC installers, electricians, and sheet metal workers reach for this style of fastener when joining thin metal components where a self-tapping thread form is needed. The pan head profile sits flush against the material surface without countersinking, making it appropriate where a low-profile clamping surface is preferred.

Key Features

• No. 10 thread size with 2-inch length under head for reliable engagement in light-gauge sheet metal
• Pan head profile provides a broad clamping surface without requiring a countersunk hole
• Phillips drive compatible with standard No. 2 screwdrivers and bit drivers
• Type A / Type AB point self-starts in pre-punched or drilled holes
• Grade 2 steel construction with zinc finish for basic corrosion resistance in dry environments
• Sold individually with a minimum order quantity of 100 units for job-site volume use

Compatibility

Designed as a standard No. 10 pan head sheet metal screw suitable for use with light-gauge sheet metal assemblies, HVAC ductwork, electrical enclosures, and similar thin-metal fabrication applications where a Type A or Type AB self-tapping point is specified.

Installation Notes

Sheet metal screws of this type are installed by sheet metal workers, HVAC technicians, and electricians using a No. 2 Phillips bit in a power screwdriver or drill. Ensure the receiving material is pre-punched or drilled to the correct pilot hole diameter for a No. 10 screw before driving. Avoid over-torquing, which can strip the thread form in thin-gauge material. Follow applicable local codes and manufacturer guidelines for fastener spacing in duct and enclosure assemblies.