Value Collection R50000184 Carriage Bolt 10-24 3/4 in

Product Description

The VALUE COLLECTION R50000184 is a 10-24 carriage bolt designed for general fastening applications where a flush, rounded head and anti-rotation square neck are required. The square neck beneath the domed head pulls into the workpiece material as the nut is tightened, preventing the bolt from spinning without the need for a wrench on the head. Built to ASTM A307 standards from Grade 2 steel with a zinc-plated finish, this fastener delivers adequate shear and tensile strength for light-to-medium-duty structural and assembly work. The 3/4 inch length under head suits thin material stacking and bracket applications common in mechanical, plumbing, and general construction trades.

This carriage bolt is suited for residential and light commercial applications including equipment mounting, support framing, and fixture attachment. The UNC thread form is the standard inch-series coarse thread, compatible with standard 10-24 hex nuts, wing nuts, and threaded inserts. The zinc plating provides basic corrosion resistance appropriate for interior or sheltered exterior installations. Sold individually per unit with a minimum order quantity of 100 pieces, making this fastener practical for stocking in job-site kits or shop inventory.

Key Features

• Square neck design locks bolt in place during tightening, eliminating the need to hold the head
• Grade 2 steel construction meets ASTM A307 fastener standard for light-to-medium structural use
• Zinc-plated finish provides basic corrosion resistance for interior and sheltered installations
• 10-24 UNC thread is a standard coarse inch-series thread compatible with widely available hardware
• 3/4 inch length under head suits thin panel, bracket, and light framing connections
• Minimum order quantity of 100 pieces supports bulk job-site and shop stocking

Compatibility

Designed for use with standard 10-24 UNC hex nuts, wing nuts, and threaded inserts in inch-series fastening applications across mechanical, construction, and general assembly work.

Installation Notes

Installation is performed by hand or with standard trade tools. Insert the bolt through a pre-drilled or punched hole sized for the shank diameter, allowing the square neck to seat into the material as the nut is run down. Tighten the nut with a wrench to draw the head flush and lock the neck in place. Do not use impact tools on the nut until the square neck is fully seated, as this may strip the neck pocket before proper engagement.