Value Collection R48622822 Low Socket Cap Screw 3/8-16

Product Description

The VALUE COLLECTION R48622822 is a low socket cap screw designed for applications where standard cap screw head height creates clearance problems. Threaded 3/8-16 UNC with a 1-inch length measured under the head, this fastener is machined from 18-8 stainless steel for corrosion resistance in wet, chemical, or outdoor service environments. Drive is a 3/16-inch hex socket, which accepts a standard Allen key or hex bit driver. The low-profile head reduces total installed stack height without sacrificing clamping strength, making it a practical choice for close-tolerance assemblies.

This screw suits mechanical, HVAC, plumbing, electrical enclosure, and general industrial assembly work where a flush or near-flush fastener profile is required. It is commonly used in panel mounting, equipment housings, pump flanges, and structural brackets where overhead or side clearance is limited. The UNC thread form is compatible with standard inch-series tapped holes and threaded inserts. Minimum order quantity is 5 pieces; the part is sold individually in quantities of 1.

Key Features

• Low socket cap head profile reduces installed height compared to standard socket cap screws
• 18-8 stainless steel construction resists corrosion in wet and mildly chemical environments
• 3/8-16 UNC thread engages standard inch-series tapped holes and threaded inserts
• 3/16-inch hex socket drive accepts common Allen keys and hex bit sets
• Length measured under head for consistent installation depth across assemblies

Compatibility

Designed as a direct-fit replacement or new-installation fastener for any application requiring a 3/8-16 UNC low socket cap screw in 18-8 stainless steel with a 3/16-inch hex socket drive.

Installation Notes

Installation requires a 3/16-inch hex key or hex bit rated for the fastener size. Verify the mating tapped hole is clean, free of debris, and cut to UNC thread standard before driving. Apply thread-locking compound or anti-seize as required by the application and relevant industry standards. Do not exceed the torque capacity of the 18-8 alloy — refer to a standard fastener torque chart for 3/8-16 stainless steel at the required clamp load.