Value Collection PFMS0080075CZ 8-32 X 3/4 in Flat Phillips Screw

Product Description

The VALUE COLLECTION PFMS0080075CZ is an 8-32 UNC machine screw designed for general fastening applications in mechanical assemblies, electrical enclosures, HVAC equipment panels, and light fixtures. This screw features a flat head with a Phillips drive, allowing it to sit flush with or below the mating surface when installed in a countersunk hole. Constructed from Grade 2 steel with a zinc plating finish, it provides basic corrosion resistance suitable for indoor and protected environments. The overall length is 3/4 inches, which matches the length under the head on this flat head configuration.

This fastener is suited for use in residential and light commercial applications where an 8-32 UNC thread and a flush-mount head profile are required. Typical uses include panel assembly, equipment mounting, junction box covers, motor brackets, and general sheet metal or tapped-hole fastening. The zinc-plated finish makes it appropriate for dry or lightly humid indoor environments. These screws are sold in multiples of 100, making them practical for shop stock, service vehicle inventory, or job-site use by electricians, HVAC technicians, and general contractors.

Key Features

• 8-32 UNC thread for compatibility with standard tapped holes and threaded inserts in that size
• Flat head profile sits flush or below surface when installed in a countersunk hole
• Phillips drive for use with standard Phillips screwdrivers or bits
• Grade 2 steel construction provides adequate strength for light-duty fastening
• Zinc plating offers basic corrosion resistance in dry indoor environments
• Overall length of 3/4 inches with full-length thread under the head

Compatibility

Designed as a standard 8-32 UNC replacement or stock fastener for use in any application requiring an 8-32 flat head Phillips machine screw with a 3/4 inch overall length.

Installation Notes

Installation requires a countersunk hole sized for an 8-32 flat head screw to achieve a flush finish. Use a Phillips screwdriver or bit driver sized appropriately to avoid cam-out and head damage. Ensure the mating hole is properly tapped or threaded to 8-32 UNC specification before driving. Do not overtighten, as Grade 2 steel has lower tensile strength than higher-grade fasteners and may strip in soft base materials.