Value Collection P20171 Standard Clevis Pin 1 in Zinc Steel

Product Description

The VALUE COLLECTION P20171 is a standard clevis pin designed for use in mechanical linkage and pivot applications where a reliable, removable fastener is required. Machined from 1010-1018 grade steel with a zinc-plated finish for corrosion resistance, this pin measures 1 inch in diameter and 3 inches overall length (OAL), with a usable length of 2-51/64 inches. The 13/64 inch cross-hole accepts a standard cotter pin or snap ring to secure the pin in place during operation. Maintenance technicians, millwrights, and general tradespeople install this type of fastener in a wide range of structural and mechanical assemblies.

This clevis pin is suited for use in clevis-and-yoke linkages, control rod connections, hinge assemblies, and other pivot-point applications found in industrial equipment, HVAC actuator linkages, and mechanical control systems. The zinc-plated steel construction makes it appropriate for indoor and moderately protected outdoor installations where mild corrosion resistance is needed. The standard geometry and common 1-inch diameter sizing make it a straightforward replacement or new-installation fastener for many production and maintenance environments.

Key Features

• 1 inch pin diameter for high-load clevis and yoke applications
• 3 inch overall length with 2-51/64 inches of usable engagement length
• 13/64 inch cross-hole sized for standard cotter pins or snap rings
• 1010-1018 steel construction provides reliable mechanical strength
• Zinc-plated finish adds corrosion resistance for extended service life

Compatibility

Designed as a standard-geometry clevis pin for use in mechanical linkage assemblies requiring a 1-inch diameter pin with a 13/64-inch retaining hole.

Installation Notes

Installation is performed by maintenance technicians or millwrights following standard mechanical fastener practices. De-energize or lock out any actuated or powered mechanism before inserting or removing the clevis pin. Align the cross-hole with the retaining hole in the clevis bracket and secure with an appropriate cotter pin or snap ring. Verify that the retaining device is fully seated before returning the assembly to service.