Value Collection NG09030 Galvanized Pipe Nipple 2in Sch 40

Product Description

The VALUE COLLECTION NG09030 is a galvanized steel pipe nipple designed for threaded piping assemblies in plumbing, HVAC, and industrial distribution systems. Measuring 2 inches in nominal pipe size and 3 inches in length, this Schedule 40 nipple features full NPT threads on both ends conforming to ANSI/ASME B1.20.1 standards. The hot-dip galvanized coating provides corrosion resistance for wet, outdoor, or moderately corrosive environments. At 0.83 pounds, it is sized for straightforward installation into standard threaded fittings, valves, and flanges. Licensed plumbers and pipefitters are the typical installers for this type of fitting.

This pipe nipple is suited for residential and light commercial plumbing supply lines, steam distribution, gas piping where local codes permit galvanized steel, and general-purpose fluid conveyance. Schedule 40 wall thickness meets the dimensional requirements of ASTM A53, ASTM A106, and ASTM A733, making it appropriate for a wide range of pressure and temperature service conditions in threaded pipe systems.

Key Features

• 2-inch nominal pipe size with 3-inch overall length
• Schedule 40 wall thickness per ASTM A53 and ASTM A733
• NPT threads on both ends per ANSI/ASME B1.20.1
• Galvanized steel construction for corrosion resistance
• Meets multiple international standards including BS 1387, DIN 2440, and ISO 7/1

Compatibility

Designed as a standard Schedule 40 threaded pipe nipple compatible with 2-inch NPT fittings, valves, couplings, and flanges used in residential and commercial threaded pipe systems.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local plumbing codes and the International Plumbing Code (IPC) or IFGC where gas service applies. Shut off the water or gas supply and depressurize the line before removing or installing any threaded fitting. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly. Do not over-tighten threaded connections, as this can crack fittings or distort threads.