Value Collection NG08100 Pipe Nipple 1-1/2 in X 10 in Sch 40

Product Description

The VALUE COLLECTION NG08100 is a galvanized steel pipe nipple sized at 1-1/2 inches nominal pipe size and 10 inches in length. It is threaded on both ends to ANSI/ASME B1.20.1 standards, making it a direct-connect fitting for joining sections of pipe or connecting to valves, fittings, and equipment. Schedule 40 wall thickness provides the structural rating appropriate for standard pressure plumbing, gas distribution, and mechanical piping systems. Licensed plumbers and pipefitters install this nipple in residential and commercial applications where a corrosion-resistant galvanized finish is required. The part weighs approximately 2.04 pounds.

This nipple is suited for residential and light commercial plumbing, HVAC condensate and water supply lines, gas distribution piping, and mechanical room assemblies where galvanized steel is the specified material. Schedule 40 construction meets the load demands of typical service water and low-pressure gas systems. It is appropriate wherever a threaded, rigid steel nipple of this length is called out in the system design or code specification.

Key Features

• 1-1/2 inch nominal pipe size, 10 inches in length — threaded both ends for direct inline connection
• Schedule 40 wall thickness for standard-service pressure plumbing and gas piping
• Galvanized steel construction provides corrosion resistance in wet or exposed environments
• Threads conform to ANSI/ASME B1.20.1 for reliable, leak-resistant joints
• Meets multiple international standards including ASTM A53, ASTM A106, ASTM A733, BS 1387, DIN 2440, and ISO 7/1

Compatibility

Designed as a standard Schedule 40 galvanized steel pipe nipple compatible with 1-1/2 inch NPT threaded fittings, valves, and couplings used in residential and commercial plumbing and gas piping systems.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local plumbing and mechanical codes, including IPC and IFGC requirements where relevant. Shut off the water or gas supply and relieve system pressure completely before breaking any threaded connection. Apply an appropriate thread sealant or PTFE tape to male threads before assembly, and use a pipe wrench to achieve a proper wrench-tight joint without over-stressing the fitting. Do not install in systems or with fluids for which galvanized steel is not rated by the applicable code.