Value Collection NG06090 Pipe Nipple 1 in 9 in Sch 40

Product Description

The VALUE COLLECTION NG06090 is a galvanized steel pipe nipple designed for threaded pipe assemblies in plumbing, HVAC, and general industrial piping systems. Machined to Schedule 40 wall thickness and threaded on both ends per ANSI/ASME B1.20.1, this nipple provides a reliable, leak-resistant connection between fittings, valves, and pipe runs. The hot-dip galvanized finish resists corrosion in wet and moderate outdoor environments. At 1 inch nominal pipe size and 9 inches in length, it bridges common spacing gaps without requiring a cut-to-length pipe segment. Weight is 1.18 pounds. Licensed plumbers and pipefitters are the primary installers.

This nipple is suited for residential and light commercial plumbing distribution lines, gas supply rough-in work where galvanized steel is permitted by local code, hydronic heating piping, and industrial fluid transfer applications. It fits standard 1-inch NPT threaded fittings and valves. The Schedule 40 wall thickness handles typical working pressures found in domestic water supply and low-pressure gas distribution systems. It is sold individually and is a direct drop-in for any application requiring a 1-inch, 9-inch galvanized nipple.

Key Features

• Schedule 40 wall thickness for standard working pressure applications
• Threaded on both ends per ANSI/ASME B1.20.1 for leak-resistant NPT connections
• Galvanized steel construction provides corrosion resistance in wet environments
• Meets multiple standards including ASTM A53, ASTM A733, and ISO 7/1
• 1-inch nominal pipe size fits standard NPT fittings and valves

Compatibility

Designed as a standard replacement or new-installation nipple for any piping system using 1-inch NPT threaded connections and Schedule 40 galvanized steel pipe.

Installation Notes

Installation is performed by a licensed plumber or pipefitter. Shut off and depressurize the supply line before removing or installing any threaded pipe component. Apply an appropriate thread sealant or PTFE tape to male threads before assembly; do not over-tighten, as this can crack cast fittings. Where used in gas applications, verify local code acceptance of galvanized steel and pressure-test the assembly before returning the system to service.