Value Collection NFC5041 Toggle Bolt Anchor 1/8x4 in

Product Description

The VALUE COLLECTION NFC5041 is a steel toggle bolt anchor designed for fastening into hollow wall and drywall assemblies. This zinc-finished anchor measures 1/8 inch in diameter with an overall length of 4 inches and accepts a 1/8-inch screw. It is rated for a maximum load capacity of 310 pounds and features a slotted/Phillips drive for straightforward installation. Electricians, plumbers, and general contractors use this type of anchor when mounting equipment, conduit hangers, brackets, or fixtures to walls where solid backing is not available. The toggle bolt design spreads the load across the back face of the wall panel for a secure hold.

This anchor is suited for use in hollow tile, plaster, wallboard, and concrete or masonry substrates. It is appropriate for both residential and light commercial applications where a reliable hollow-wall fastener is needed. Typical install scenarios include mounting electrical enclosures, pipe straps, HVAC brackets, or other trade hardware to finished interior walls. The zinc finish provides basic corrosion resistance in standard indoor environments.

Key Features

• 310-pound maximum load capacity for dependable hollow-wall holding strength
• Steel construction with zinc finish for durability and corrosion resistance
• Slotted/Phillips drive accepts common screwdrivers and combination bits
• 1/8-inch diameter x 4-inch overall length suits a range of wall thicknesses
• Compatible with hollow tile, plaster, wallboard, and concrete/masonry substrates

Compatibility

Designed as an OEM-style toggle bolt anchor for use in hollow tile, plaster, wallboard, and concrete or masonry wall assemblies in residential and light commercial installations.

Installation Notes

Toggle bolt anchors of this type are installed by electricians, plumbers, pipefitters, and general trade contractors. Before installation, ensure the wall cavity is clear of wiring, piping, or insulation in the drill path. Drill a hole sized to allow the folded toggle wings to pass through, then insert the toggle and tighten the screw until the wings seat firmly against the back of the wall panel. Do not overtighten, as excessive torque can pull the toggle through the facing material.