Value Collection NB09055 Black Steel Pipe Nipple 2 in Sch 40

Product Description

The VALUE COLLECTION NB09055 is a black steel pipe nipple used to connect sections of threaded pipe in plumbing, gas distribution, and industrial piping systems. It measures 2 inches in nominal pipe size and 5.5 inches in length, with a Schedule 40 wall thickness. Both ends carry NPT threads conforming to ANSI B1.20.1 and ASME B1.20.1 standards. The black finish is standard for gas service and steam applications where galvanized coating is not required. Plumbers, pipefitters, and mechanical contractors install this nipple as a short extension or coupling offset between fittings, valves, and equipment connections.

This nipple suits residential and light commercial applications including natural gas lines, propane distribution, steam heating systems, and general water service where Schedule 40 carbon steel is specified. It threads directly into standard 2-inch NPT fittings, tees, elbows, unions, and valves. The 5.5-inch length provides adequate reach for close-quarter offsets and equipment connections where a close or hex nipple would be too short.

Key Features

• Schedule 40 wall thickness meets standard pressure ratings for gas and water service
• NPT threads on both ends conform to ANSI B1.20.1 and ASME B1.20.1
• Black finish suitable for gas piping and steam service
• Carbon steel construction provides durability in mechanical and utility piping
• ASTM material compliance supports use in code-required installations

Compatibility

Designed as a standard replacement or new-installation nipple for 2-inch NPT threaded piping systems built to Schedule 40 requirements in gas, steam, and water service applications.

Installation Notes

Installation is performed by a licensed plumber or pipefitter following applicable local codes, IFGC requirements for gas service, or IPC requirements for water service. Apply an approved pipe thread sealant or PTFE tape to all male threads before assembly. Tighten with a pipe wrench to proper engagement — do not overtighten, as this can crack fittings. Pressure-test the assembled system before returning it to service.