Value Collection MSC-62148069 Malleable Iron Pipe Bushing

Product Description

The VALUE COLLECTION MSC-62148069 is a galvanized malleable iron pipe bushing designed to reduce a 1/2-inch female pipe thread to a 3/8-inch male pipe thread. Malleable iron construction gives this bushing the ductility and impact resistance needed for threaded piping systems in mechanical, plumbing, and industrial applications. Rated at 300 psi for liquid and gas service and 150 psi for steam, it meets Class 150 pressure standards. The galvanized finish provides corrosion resistance in exposed or damp environments. Plumbers, pipefitters, and HVAC technicians install this type of fitting when adapting between pipe sizes within a threaded assembly.

This bushing is suited for residential and light commercial piping systems carrying water, air, gas, or steam within its rated pressure limits. It threads directly into a 1/2-inch female-threaded fitting or pipe end, accepting 3/8-inch male pipe thread on the opposite end. Typical install locations include gas distribution manifolds, compressed air lines, water supply lines, and heating system piping where a threaded reducer is needed without adding a coupling and nipple combination.

Key Features

• Malleable iron construction resists cracking and deformation under mechanical stress
• Galvanized finish provides corrosion resistance for exposed or damp service environments
• 300 psi liquid and gas pressure rating for demanding fluid and gas piping applications
• 150 psi steam pressure rating suitable for low-pressure steam heating systems
• Class 150 rated for use in standard threaded pipe assemblies
• Reduces 1/2-inch female thread to 3/8-inch male thread in a single compact fitting

Compatibility

Designed as an OEM-style replacement and standard-fit bushing for Class 150 malleable iron threaded pipe systems using NPT connections in plumbing, HVAC, and industrial piping applications.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC and IFGC code requirements for the service type. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly. Hand-tighten first, then wrench-tighten to a snug fit without overtightening, which can crack malleable iron fittings. Shut off and depressurize the piping system fully before removing or installing any threaded fitting.