Value Collection MS35206-268 Pan Head Machine Screw 10-24

Product Description

The VALUE COLLECTION MS35206-268 is a 10-24 pan head machine screw with a Phillips drive, manufactured from steel with a yellow cadmium finish. It measures 1-1/4 inches in length under the head and meets Grade 3 material standards under the MS35206 fastener specification. This screw is designed for metal-to-metal fastening applications where a low-profile pan head and corrosion-resistant cadmium coating are required. It is commonly installed by maintenance technicians, electricians, HVAC service professionals, and military or aerospace-adjacent tradespeople working with MIL-spec hardware.

This machine screw is suited for general industrial and trade-service applications requiring a standardized inch-series threaded fastener. The 10-24 thread designation indicates a number 10 diameter with 24 threads per inch, making it appropriate for light structural and panel-mounting tasks. The yellow cadmium finish provides corrosion protection and is consistent with military fastener standards under the MS35206 specification. It installs in pre-tapped holes or with a mating nut in sheet metal panels, enclosures, and equipment housings typical in HVAC, electrical, and industrial maintenance work.

Key Features

• 10-24 UNC thread size for compatibility with standard inch-series tapped holes
• Pan head profile provides a low-profile, wide bearing surface
• Phillips drive allows installation with standard Phillips screwdrivers and bit drivers
• Steel construction with yellow cadmium finish for corrosion resistance
• Grade 3 material rating per MS35206 military fastener standard
• No washer — clean installation in close-tolerance applications

Compatibility

Designed as an OEM-style replacement or service fastener for applications requiring an MS35206-specification 10-24 pan head Phillips machine screw in inch-series measurement.

Installation Notes

Install into a properly tapped 10-24 hole or use with a matching hex nut. Power down or de-energize any equipment before replacing fasteners on electrical panels or enclosures, in accordance with NEC lockout-tagout requirements. Use a correctly sized Phillips bit to avoid cam-out and head damage. Do not overtighten in thin sheet metal applications — hand-snug plus a quarter turn is generally appropriate for light panel work.