Value Collection MS01B7195B Worm Gear Clamp Sae 52

Product Description

The VALUE COLLECTION MS01B7195B is a worm gear clamp rated SAE Size 52, designed to secure hose and tubing connections in plumbing, HVAC, and general mechanical applications. The clamp features a stainless steel and carbon steel band that is 0.5 inches wide, with an adjustment range spanning 2.75 inches to 3.75 inches in diameter. The band material meets Material Grade 201 stainless steel standards, providing corrosion resistance suitable for a range of fluid-handling and air-handling installations. Licensed plumbers, HVAC technicians, and mechanical contractors rely on this clamp type for reliable, tool-tightened connections on rubber hose, flexible duct collars, and similar fittings.

This worm gear clamp is suited for residential and light commercial installations where hose-to-barb, hose-to-nipple, or hose-to-fitting connections require a secure, adjustable band clamp. Typical applications include coolant lines, drain connections, condensate hose fittings, and flexible duct boot attachments. The SAE 52 size designation makes it straightforward to cross-reference and replace worn or failed clamps during service calls without measuring from scratch.

Key Features

• SAE Size 52 worm drive clamp with adjustment range of 2.75 to 3.75 inches diameter
• Stainless steel and carbon steel band construction, Material Grade 201
• Band width of 0.5 inches for consistent clamping pressure across the hose bead
• Worm gear drive mechanism allows precise tightening with a standard slotted or hex-head screwdriver or nut driver
• UNSPSC Code 31171712 for straightforward procurement and catalog matching

Compatibility

Designed as a standard SAE 52 worm gear clamp suitable for hose and tubing connections with an outside diameter between 2.75 inches and 3.75 inches across plumbing, HVAC, and general mechanical applications.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or mechanical contractors using a flathead screwdriver or 5/16-inch hex nut driver. Shut off the relevant fluid or air supply before removing the existing clamp and fitting the replacement. Position the clamp so the screw housing does not bear directly against sharp edges or fittings that could damage the band over time. Tighten gradually and evenly to seat the clamp without distorting the hose.