Value Collection MPTI02501500-025B 1/4-20 Truss Head Screw

Product Description

The VALUE COLLECTION MPTI02501500-025B is a 1/4-20 x 1-1/2 inch machine screw with a truss head and Phillips drive, manufactured from Grade 2 steel with a zinc-plated finish. The truss head profile sits low and wide, distributing clamping load over a larger surface area than a standard pan head. The zinc plating provides basic corrosion resistance suitable for general indoor and light-duty fastening applications. This screw follows the Unified National Coarse (UNC) thread standard and measures length under head at 1-1/2 inches. It is a common fastener installed by electricians, HVAC technicians, plumbers, and general maintenance tradespeople across a wide range of assembly and equipment-mounting tasks.

This fastener is suited for light structural assembly, equipment panels, junction box covers, electrical enclosures, and general mechanical assembly where a low-profile head is required. The Phillips drive is compatible with standard #2 Phillips bits. The 1/4-20 UNC thread is one of the most widely used coarse-thread sizes in trade applications, making this screw a practical stock item for service vans and shop inventory. Minimum order quantity is 50 pieces per package.

Key Features

• 1/4-20 UNC coarse thread for broad compatibility with standard tapped holes and hex nuts
• Truss head profile provides a wide, low-profile bearing surface
• Phillips drive accepts standard No. 2 Phillips bit or screwdriver
• Grade 2 steel construction offers adequate tensile strength for light-duty fastening
• Zinc-plated finish for basic corrosion resistance in dry or indoor environments
• Length under head: 1-1/2 inches, no washer face

Compatibility

Designed for use in any standard 1/4-20 UNC tapped hole or with a corresponding 1/4-20 nut, suitable for metal, plastic, and light structural assembly applications where a truss head fastener is specified.

Installation Notes

Install with a No. 2 Phillips screwdriver or bit driver set to an appropriate clutch setting to avoid cam-out or overdriving. De-energize and lock out any equipment before fastening panels or enclosures per NFPA 70E safe work practices. Do not use in applications requiring a higher material grade or corrosion resistance beyond basic zinc plating without verifying suitability for the environment.