Value Collection MPRI-1001500-100BX Machine Screw 10-24

Product Description

The VALUE COLLECTION MPRI-1001500-100BX is a 10-24 UNC machine screw with a round head and Phillips drive, sold in a box of 100. The screw measures 1.5 inches in length, measured under the head. It is made from Grade 2 steel with a zinc plating that provides basic corrosion resistance in light-duty applications. This fastener is suited for general assembly and maintenance tasks across mechanical, electrical, and light industrial work. Licensed electricians, HVAC technicians, and maintenance mechanics commonly use this screw size for panel work, bracket mounting, and equipment enclosures.

The 10-24 thread size is one of the most common inch-series coarse-thread fastener sizes in trade applications. This screw is well suited for metal-to-metal fastening in control panels, junction boxes, equipment housings, and light structural assemblies. The Phillips round head provides a low-profile bearing surface and is compatible with standard Phillips-head screwdrivers and power bits. The zinc finish adds a layer of protection against oxidation in dry or mildly humid indoor environments. These are sold in a box of 100 units.

Key Features

• 10-24 UNC thread form for compatibility with standard tapped holes and hex nuts
• Round head Phillips drive for secure seating in light-gauge panels and enclosures
• Grade 2 steel construction provides adequate tensile strength for general-purpose fastening
• Zinc plating offers basic corrosion resistance for indoor and dry-location use
• 1.5-inch length under head suits moderate material stack thicknesses
• Packaged in quantities of 100 for efficient stocking and service van inventory

Compatibility

Designed as a general-purpose inch-series machine screw for use in any application requiring a 10-24 UNC thread with a round head Phillips drive configuration.

Installation Notes

Install using a standard No. 2 Phillips screwdriver or a power driver with a No. 2 Phillips bit. When fastening into tapped holes in electrical enclosures or control panels, de-energize all circuits before beginning work in accordance with NFPA 70 lockout and tagout procedures. Do not overtighten into thin sheet metal, as the Grade 2 material is not rated for high-clamp load applications. Use appropriate thread-locking compound if vibration resistance is required.