Value Collection MPPI0-600310-100BX Machine Screw 100 Pack

Product Description

The VALUE COLLECTION MPPI0-600310-100BX is a 6-32 x 5/16 inch pan head machine screw with a Phillips drive, supplied in a box of 100. Manufactured from Grade 2 steel with a zinc-plated finish, these screws are suited for general-purpose fastening applications across electrical, mechanical, and light fabrication work. The 6-32 unified coarse (UNC) thread and pan head profile are among the most commonly specified configurations in panel assembly, enclosure work, and equipment mounting. Length is measured under the head.

These screws are widely used in residential and commercial trade applications wherever a small-diameter, corrosion-resistant fastener is required. Typical uses include securing terminal covers, control board mounts, electrical panels, and sheet metal enclosures. The zinc plating provides basic corrosion resistance for indoor and light-duty environments. The box quantity of 100 suits service vans, shop stock, and job-site kits where consistent replenishment of standard hardware is needed.

Key Features

• 6-32 UNC thread for compatibility with standard tapped holes in panels and enclosures
• Pan head profile provides a low-profile, broad bearing surface without a washer
• Phillips drive for use with standard Phillips screwdrivers and power bits
• Grade 2 steel construction for general-purpose strength requirements
• Zinc-plated finish for basic corrosion resistance in indoor applications
• Sold in a 100-count box for efficient stock management

Compatibility

Designed as a general-purpose 6-32 UNC pan head machine screw suitable for standard tapped or pre-threaded holes in electrical enclosures, control panels, and light mechanical assemblies.

Installation Notes

These screws are installed by electricians, HVAC technicians, and mechanical trades using a Phillips screwdriver or matching power bit. De-energize all electrical equipment before fastening or removing screws near live components. Do not overtighten into plastic or thin sheet metal bosses, as Grade 2 fasteners can strip soft materials if excessive torque is applied. Follow applicable NEC or equipment manufacturer guidelines when securing electrical panel components.