Value Collection MPFI0-800750-100BX 8-32 Flat Head Phillips Screw

Product Description

The VALUE COLLECTION MPFI0-800750-100BX is a Unified National Coarse (UNC) machine screw designed for general-purpose fastening in metal, plastic, and composite assemblies. This 8-32 thread screw measures 3/4 inches in overall length and features a flat, countersunk head driven by a Phillips bit. Manufactured from Grade 2 steel with a zinc plating for basic corrosion resistance, it suits indoor mechanical assemblies, electrical enclosures, panel mounting, and light structural work. Licensed trades and maintenance technicians reach for this screw when a flush-mount fastener is needed in pre-tapped holes or threaded inserts.

This screw is suited for residential and light commercial applications where an 8-32 threaded hole or nut is already present. Common install scenarios include electrical panel work, control board mounting, equipment covers, junction boxes, and HVAC cabinet assembly. The flat head seats flush against the mating surface, eliminating protrusions that could interfere with covers or adjacent components. Sold in a package quantity of one unit with a minimum order quantity of 50 pieces.

Key Features

• 8-32 UNC thread form for broad compatibility with standard tapped holes and nuts
• Flat countersunk head sits flush with the mating surface for clean, low-profile installs
• Phillips drive for use with standard Phillips bits and screwdrivers
• Grade 2 steel construction provides adequate tensile strength for light to medium fastening loads
• Zinc plating offers basic protection against oxidation in dry indoor environments
• 3/4-inch overall length suits panels and enclosures with standard wall thicknesses

Compatibility

Designed as a standard 8-32 UNC flat head machine screw compatible with any pre-tapped 8-32 hole, threaded insert, or hex nut of the same thread specification.

Installation Notes

Installation is performed with a Phillips screwdriver or Phillips bit driver sized for a No. 2 bit. Verify the mating hole is clean and fully threaded to 8-32 UNC spec before driving. Do not overtighten Grade 2 fasteners in thin sheet metal, as the material may strip. When used inside energized electrical enclosures, de-energize and lock out the equipment per NFPA 70E requirements before beginning work.